General SET-UP Outline :

1. Mount and cable PUEO
2. Install Focam session (Jim)
3. Check (not extensive) that communication is OK with real-time computer and with Prolog. This may involve :
   • Moving a mirror (e.g. tvm 1)
   • Verify that real-time display works
4. Adjust amplitude of the membrane mirror :
   • Astar 1 15
   • Turn ON PUEO's ISIT camera
   • tvm 2
   • set Gopt to 128 (Maintenance UI)
   • Center Astar and WFS (superimpose the two extrafocal images)
   • Set the tip-tilt channel 1 to 1 volt (Maintenance UI)
   • Adjust the frequency (knob, front panel of WFS electronics) in order to get a edge to edge deviation of 88 mm on the screen
   • Put back in initial conditions (o Volt on TT, tvm 0, ISIT OFF)
5. Adjust the phase of the lock in detection :
   • Astar 1 15
   • Flux goes to APDs, Astar rougthly centered
   • Adjust phase (wheel with two hexa numbers, front panel of WFS electronics) so that the analog display shows "zero" (flux are balanced)
6. Make sure we are using the right aosave.ao (the one taken in Feb)
7. Close the loop to make sure that everything is allright (in particular, check that no actuator goes to limit).
8. Optionnaly, compute a "fresh" set of offset voltages
9. Measure the best WFS focus position for each filter (jim knows)