1. Introduction
   1. Purpose
   2. Usage
2. Guide TV camera
   1. Camera setup
   2. Equipment setup
   3. Power on camera
   4. Check that the camera sees light
3. TCS clocks
   1. DATE command
   2. Reset TCS solar clock
   3. Reset sidereal time
   4. Reset the System D computer
      1. Possible reset scenarios for this computer
      2. Boot procedure
4. Telescope focus:
   1. TCS focus readout
   2. Troubleshooting focus problems
   3. encoder problems
5. M2 Operations
   1. the M2 command
   2. check for proper status
   3. reposition the mirrors
   4. troubles moving the mirrors
6. Autoguider system:
   1. A/G handpaddle extension to Upper Coudé
   2. AGBOX sees image in box
7. Setting up the HP 1000 terminal
   1. Hard reset
   2. Switch settings
   3. Terminal troubleshooting
      1. no prompt, or dead terminal
      2. terminal only uses a portion of screen width
      3. terminal only uses a portion of screen height
      4. terminal operates slowly
8. Logging on to the TCS
   1. Already running?
   2. Log in prompt
   3. Log in
9. Entering TCS III commands
   1. User interface:
   2. Prompts
   3. Execution
   4. Help
10. Logging off the TCS
    1. Get prompt
    2. Clear screen
11. Troubleshooting the TCS computer
    1. Terminal problems
    2. Computer self-check
    3. Additional tests
       1. FPP test
       2. FFP test
       3. SIS test
       4. VIS test
    4. Booting problems
       1. RUN light will not stay on
       2. System starts, then no more activity
12. Booting the TCS computer
    1. Location
    2. Front panel sequence
    3. Boot completion
13. Switching to the backup TCS computer
    1. Stop the primary computer
    2. Flip the R-Buss switch
    3. Switch the T.O. console
    4. Start backup computer
    5. Log on to the backup computer
    6. Backup computer status
14. Getting the telescope ready for operation:
    1. Make sure it is OK for you to be moving the telescope
    2. Get the TELESCOPE KEY
    3. Ensure telescope hydraulics are on, and pressure is OK
    4. Ensure air pressure is up, and OK
    5. Ensure the telescope servo amplifiers are on
    6. Unlock the telescope
15. Simple telescope operations
    1. Prepare the telescope
    2. Put the TCS in computer mode
    3. Safety check
    4. Enter the position to slew to
    5. Initiate the slew
    6. Stopping the telescope
    7. normal completion
       1. STOP command
       2. emergency stops
16. Simple manual mode telescope operations
    1. Prepare the telescope
    2. Safety check
    3. Get the TCS out of computer mode
    4. Slew the telescope
    5. Considerations on using Manual Mode
       1. safety
       2. operational
17. Telescope limits
    1. End of axis travel limits
       1. hard limits
       2. soft limits
    2. Horizon limits
       1. 3 deg limit
       2. 8 deg limit
    3. Long instrument limits
    4. Response to limit indications
       1. 8 deg limit transient activation
       2. 8 deg limit constant activation
       3. 3 deg limit constant activation
       4. axis end of travel hard limit constant activation
    5. Exceptions